Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions
section of this manual.
ON/OFF
Turns the unit on or off.
MODE
OK
TIMER
SHORTCUT
CLEAN
LED
Turbo
SLEEP
Scrolls through operation modes
as follows:
AUTO
COOL
DRY
HEAT
FAN
FAN SPEED
SWING
Model:
TEMP
04
Used to confirm the selected
functions
Decreases temperature
O O
in 1 C(1 F) increments.
Min. temperature is
O
RG10B(F/H/G)/BGEF,RG10B(S)/BGEF
O
17 C(62 F).
Increases temperature
O O
in 1 C(1 F) increments.
Max. temperature is
O O
30 C(86 F).
Set timer to turn unit on or off.
Saves energy during sleeping
hours.
Selects fan speeds in the
following order:
AUTO LOW MED HIGH
NOTE: Holding this button
down for 2 seconds will activate
Silence feature.
Enables unit to reach preset
temperature in shortest
possible time
Used to restore the current
settings or resume previous
settings.
Starts and stops the horizontal
louver movement. Hold down
for 2 seconds to initiate vertical
louver auto swing feature.
TEMP
SET
NOTE: For model of RG10B(F1/H1/G1)/BGEFU1 , press together & buttons at the same
time for 3 seconds will alternate the temperature display between the °C & °F scale.
Scrolls through operation
functions as follows:
Fresh( )
Follow Me( )
AP mode( ) Fresh ....
The selected symbol will
flash on the display area,
press the OK button to
confirm.
Used to start/stop the Clean
function.
Turns indoor unit’s LED display
and air conditioner buzzer on and
off (modeldependent), which
create a comfortable and quiet
environment.
NOTE: HEAT mode is not
supported by cooling only
appliance.
To Next Page
Loading...