3-8 Samsung Electronics
Press the Mode Selection key to set the display part and check the display part.
→
The display part shows like below when each time you press Mode button.
Step 6
Upon completion of the selection, check you made right selections.
Step 7
Pressing the ON/OFF button ( ) .
When pressing the operation ON/OFF key with the direction of remote control for unit, the sound ’’Ding’’ or ’ring’’
and the OPERATION ICON(
) lamp of the display is ickering at the same time, then the input of option is completed.
(If the deriving sound isn’t heard, try again pressing the ON/OFF button.)
Step 8
Unit operation test-run.
First : Remove the battery from the remote control.
Second : Re-insert the battery into the remote control.
Third : Press ON/OFF key with the direction of remote control for set.
■ Error mode
1. If all lamps of indoor unit are ickering, Plug out, plug in power plug again and press ON/OFF key to retry.
2. If the unit is not working properly or all lamps are continuously ickering after setting the option code, the correct option code is
set up for its model.
□ Option Items
0RGHO 6(* 6(* 6(* 6(* 6(* 6(* 6(* 6(* 6(* 6(* 6(* 6(*
$5+6)6-:.&9 $ )
$5+6)6-:.&9 $$ $ )
$5+6)6-:.&9 $ & % )
$5+6)6-:.&9 $' (
To Next Page
Loading...