9Samsung Electronics
Set Up the Model Option
7
8
Press button, then the default value is .
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
✳ Setting is not required if you must
a value which has a default.
9
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
10
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
11
Push the button to set the display panel to .
Every time you push the button, the display panel reads
. . .
repeatedly.
12
Do not touch the button because its default is .
Unless the display panel reads , push the button to .
Step 3 : Upon completion of the selection, check you made right selections.
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Press the Mode Selection key, to set the display part to and check the display part.
The display part shows .
Step 4 : Press the ON/OFF button ( )
When pressing the operation ON/OFF key with the direction of remote controller for unit, the sound ''Ding'' or ''Diriring'' is
heard and the OPERATION ICON( ) lamp of the display is flickering at the same time, then the input of option is
completed. (If the diriring sound isn't heard, try again pressing the ON/OFF button.)
Step 5 : Unit operation test-run
First, Remove the battery from the remote controller.
Second, Re-insert the battery into the remote controller.
Third, Press ON/OFF key with the direction of remote controller for set.
• Error Mode
1
st
If all lamps of indoor unit are flickering, Plug out, plug in again and press ON/OFF key to retry.
2
nd
If the unit is not working properly or all lamps are continuously flickering after setting the option code, see if the correct option code is
set up for its model.
Tsar_DB98_15869A(1)_1 1/12/04 10:29 AM Page 9
To Next Page
Loading...
