6
No Parts Procedure Remark
Heat Exchanger
Compressor
3
4
2) Remove the nut flange (Turn to the right to
remove, as it is a left hand screw)
3) Separate the fan.
4) Loosen four fixing screws to separate the motor.
1) Do “1”, 2 above.
2) Loosen two fixing screws of left and right side.
3) Disassemble the inlet and outlet pipe by weld-
ing.
4) Separate the heat exchanger.
1) Do “1”, above.
2) Loosen the nut on the terminal cover and open
the terminal cover.
3) Disassemble the inlet and outlet pipe of
compressor by welding.
4) Disassemble the inlet and outlet pipe of
condenser by welding
5) Loosen the three bolts of the lower part.
6) Separate the compressor.
6-00187A(1)-DA 5/16/01 2:00 PM Page 6
To Next Page
Loading...
