Samsung AW078AA - Page 19

Disassembly and Reassembly
4-4 Samsung Electronics
No. Part name Procedures Remarks
$
%
^
Ass'y Control
PLATE EVAP CASING
&
TRAY DRAIN
Blower
&
Propeller Fan
1. Remove the blade V(and arm blade).
2. Remove 3 screws on the FRAME BLADE.
3. Remove the FRAME BLADE.
4. Remove 1 screw under the Base pan,
and earth wire screw.
5. Remove two lead wire assemblies.
6. Take out the control box forward.
1. Remove 2 screws on the front side.
2. Remove 4 screws on the left side.
3. Pull up the PLATE EVAP CASING and
TRAY DRAIN.
1. Remove 2 screws on the rear side (Base
pan), and 7 screws on the case cond.
2. Pull up the CONDENSER from the Base
pan.
3. Remove the nut, and remove the propeller
fan.
4. Remove the nut, and remove the
BLOWER.
DB98-04511A(1)-1 3/20/02 2:24 PM Page 4-4