Samsung AW078AA - Page 22

Disassembly and Reassembly
Samsung Electronics 4-7
No. Part name Procedures Remarks
$
%
^
Ass'y Control
PLATE EVAP CASING
&
TRAY DRAIN
Case Cond
&
Propeller Fan
1. Remove the blade V(and arm blade).
2. Remove 4 screws on the FRAME BLADE.
3. Remove the FRAME BLADE.
4. Remove 2 screws under the BASE PAN, and
earth wire screw.
5. Remove two lead wire assemblies.
6. Take out the control box forward.
1. Remove 2 srews on the front side.
2. Remove 3 screws on the left side.
3. Remove 1 screw from the Base pan.
4. Pull up the PLATE EVAP CASING and TRAY
DRAIN.
1. Remove 2 screws on the rear side (Base
pan), and 7 screws on the case cond.
2. Pull up the CONDENSER from the Base pan.
3. Remove the Nut, and remove the propeller
fan.
4. Remove the Nut, and remove the BLOWER.
DB98-04511A(1)-1 3/20/02 2:24 PM Page 4-7