E-
10
Removing Excess Humidity
☛
Remote Control
Control Panel
If the temperature is not displayed on the control panel:
◆
Press the button on the remote control
or
◆
Press the button on the unit one or more times until the
temperature is displayed.
Result
:
◆
The unit beeps each time you press the / button.
◆
The air conditioner starts up in the Cool mode.
➢
You can change modes at any time.
2
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1 If necessary, press the (On/Off) button.
Result
: ◆ The air conditioner starts up in the Cool mode.
◆ The unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
◆ Plugged in
◆ Stopped
It will start up normally after three minutes.
3 To adjust the temperature, press the
or
buttons one or
more times until the required temperature is displayed.
Possible temperatures are between
64°F and 86°F
inclusive.
Result
: ◆ Each time you press the
or
buttons:
- The temperature is adjusted by 1°F
- The unit beeps
◆ The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 11.
To Next Page
Loading...