This document is a user manual for a Samsung Window-type Room Air Conditioner (Cooling). It provides instructions for operation, programming, and maintenance, along with safety precautions and technical specifications.
Function Description:
The Samsung Window-type Room Air Conditioner is designed to cool a room, provide air circulation (fan mode), and remove excess humidity (dry mode). It features various operational modes and programmable settings to enhance user comfort and energy efficiency.
Important Technical Specifications:
The air conditioner models covered by this manual are categorized by their power supply:
- 115V~, 60Hz models: AW0503B, AW0505B, AW0509B, AW0603B, AW0605B, AW0609B, AW0803B, AW0805B, AW0809B, AW089CB, AW1003B, AW1005B, AW1009B, AW109CB, AW1203B, AW1205B, AW1209B, AW129CB, AW1403B, AW1409B, AW140CB, AW10NCB7, AW12NCB7, AW14NCB7.
- 230-208V~, 60Hz models: AW1803B, AW1805B, AW1809B, AW189CB, AW2402B, AW2404B, AW2406B, AW18NCB7.
The operating temperature and humidity ranges are crucial for optimal performance:
- Indoor Temperature: 70°F to 90°F approx.
- Outdoor Temperature: 70°F to 110°F approx.
- Indoor Humidity: 80% or less.
Operating outside these ranges can trigger automatic protection features, stop the air conditioner, cause water leakage due to heat exchanger freezing, or lead to condensation dripping from the unit.
Usage Features:
The air conditioner can be controlled via a remote control or buttons on the unit's control panel.
Cooling Your Room:
- To lower the room temperature, select the "Cool" mode.
- Press the On/Off button to start the unit in Cool mode.
- If the temperature is not displayed, press the "Cool" button on the remote or the Mode button on the unit until the temperature appears.
- Temperature can be adjusted between 64°F and 86°F using the Temp. Up/Down buttons. Each press adjusts the temperature by 1°F.
- Fan speed can be set to High, Med, or Low using the remote control or the Fan Speed button on the unit (F1, F2, or F3).
- The unit has a 3-minute protection mechanism to prevent damage if started immediately after being plugged in or stopped.
Airing Your Room (Fan Mode):
- To circulate air without cooling, use the "Fan" mode.
- Press the On/Off button to start.
- If the fan speed is not displayed, press the "Fan" button on the remote or the Mode button on the unit until the fan speed (F1, F2, or F3) appears.
- Fan speed can be adjusted to High, Med, or Low.
- In Fan mode, temperature cannot be set or displayed.
Removing Excess Humidity (Dry Mode):
- To reduce humidity without significant temperature drop, use the "Dry" mode.
- Press the On/Off button to start.
- If the temperature is not displayed, press the "Dry" button on the remote or the Mode button on the unit until the temperature appears.
- Temperature can be adjusted between 64°F and 86°F. The air conditioner automatically adjusts the quantity of air.
Adjusting Air Flow Direction:
- Horizontally: Inner air flow blades (right/left orientation) can be adjusted by sliding them side to side.
- Vertically: Outer air flow blades (up/down orientation) can be adjusted by pushing them upwards or downwards (except for models AW0503B, AW0505B, AW0509B, AW0603B, AW0605B, AW0609B). For cooling, it is recommended to adjust blades upwards to prevent dew formation and dripping.
Programming Features:
Setting the On Timer:
- Allows the air conditioner to switch on automatically after a set time (1 to 24 hours).
- Can only be set when the unit is off and operates in Cool or Dry mode.
- Press the "Timer" button on the remote or unit repeatedly to set the desired time.
- The time is adjusted by 1 hour increments and displayed on the control panel.
- Fan speed, temperature, and Energy Saving mode can be selected after setting the On timer. Changing the mode cancels the timer.
- To cancel, press "Timer" until "--" is displayed, or press the On/Off button.
Setting the Off Timer:
- Allows the air conditioner to switch off automatically after a set time (1 to 24 hours).
- Can only be set when the unit is on and operates in Cool or Dry mode.
- Press the "Timer" button on the remote or unit repeatedly to set the desired time.
- The time is adjusted by 1 hour increments and displayed on the control panel.
- Fan speed, temperature, and Energy Saving mode can be selected after setting the Off timer. Changing the mode cancels the timer.
- To cancel, press "Timer" until "--" is displayed, or press the On/Off button.
Setting the Sleep Mode:
- Switches the air conditioner off automatically after 8 hours.
- Can be set whether the unit is on or off, and in any mode.
- Press the "Sleep" button on the remote or unit. The indicator and "8" will be displayed, and the remaining time decreases in 1-hour segments.
- If set while off, the unit starts in Cool mode with temperature set to 79°F. If set while on, it runs in Cool mode at the set temperature.
- The fan runs in low mode (F1), but speed can be adjusted.
- To cancel, press the On/Off button, or press "Sleep," "E.Saver," "Timer," "Fan," or "Dry" on the remote, or "Sleep," "E.Saver," "Cool/Dry/Fan," or "Timer" on the unit.
- Selecting Energy Saving mode while in Sleep mode cancels Sleep mode.
Selecting Energy Saving Mode:
- Helps save energy.
- Press the "E.Saver" button on the remote or unit until the Energy Saver indicator lights up.
- The fan and compressor cycle on and off together; the fan continues to run for a short time after the compressor turns off.
- Cannot be used in Dry mode.
- To stop, press "E.Saver" again. The fan will run continuously, while the compressor cycles on and off.
- Selecting Sleep Timer in Energy Saving mode cancels Energy Saving and starts Sleep Timer mode.
Remote Control Batteries:
- Requires two AAA, LR03 1.5V batteries.
- Do not mix old and new batteries or different types.
- Batteries may discharge after 12 months even if unused.
- Insert batteries respecting polarity (+ and -).
Maintenance Features:
Cleaning Your Air Conditioner:
- Always turn off the air conditioner and unplug it before cleaning.
- Air Filter:
- Open the front grille by pulling the tabs on both sides and lifting it up.
- Grab the filter tabs and pull it up and out.
- Remove dust with a vacuum cleaner or brush.
- Insert the air filter back into its original position.
- Unit Surface: Wipe with a neutral detergent, then with a dry cloth. Avoid benzene, solvent, or other chemical products.
Long-Term Storage:
- If not using the air conditioner for a long period, set the fan to run for a few hours to dry the inside thoroughly.
- Switch off, unplug from the wall socket, and clean the filter and outer surfaces.
- If the unit has not been used for a long time, run the fan for a few hours to dry the inside.
Safety Precautions:
- Risk of electric shock; disconnect power before servicing, installing, or cleaning.
- Repairs should only be performed by the manufacturer, service agent, or qualified personnel.
- Do not attempt self-repair; contact a service center or the retailer.
- Do not spill liquids into the unit; unplug and contact a service center if this occurs.
- Keep children away from the unit and do not insert anything between air outlet blades.
- Do not place obstacles in front of the unit.
- Do not spray liquids into the indoor unit; switch off the breaker and contact an installation specialist.
- Ensure proper ventilation; do not cover with clothing or other materials.
- Remove remote control batteries if not used for a long time.
- Wireless remote control range is up to 7 meters.
- The air conditioner must be plugged into its own specific power source, complying with national wiring, earthing, and safety regulations.
- Damaged power cords must be replaced by the manufacturer, service agent, or similarly qualified person.
- Installation must comply with national electrical rules, and the plug should be easily accessible.
- If the PC board fuse is broken, replace it with a T 3.15A 250V type.
- The air conditioner breaker must be an all-pole switch with a contact distance of at least 3.5mm, incorporated into fixed wiring.
- When disposing of the device, remove batteries safely for recycling.
- Consult your dealer for unit disposal; incorrect pipe removal can release refrigerant, causing injury and environmental damage.
- Recycle packaging materials responsibly.
- Do not store or ship the air conditioner upside down or sideways to avoid compressor damage.
- The appliance is not intended for use by young children or infirm persons without supervision; children should be supervised to ensure they do not play with the appliance.
- Max current is measured according to IEC standard for safety and ISO standard for energy efficiency.
To Next Page
Need help?
General
