16
Installation
Attaching the Stand
―
Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
2
3
4
Place the stand neck on the monitor as shown in
the figure. Align the hollow circle on the stand neck
with the solid circle on the monitor, and then rotate
the stand neck clockwise until the solid circle on
the stand neck is aligned with that on the monitor.
Connect the cables. Cover the COVER-REAR SUB. Lift the stand neck.
5
Insert the stand base into the stand neck in the
direction as shown in the figure.
- Caution
Do not press down on the monitor. There is a risk of
damaging the monitor.
To Next Page
Loading...
