Reverse Side
―
The colour and shape of parts may differ from what is shown. Specifications are
subject to change without notice to improve quality.
RGB IN RJ45DP OUT
COMPONENT IN
DVI IN /
MAGICINFO IN
RGB / DVI /
HDMI / AV /
COMPONENT
/ AUDIO IN
HDMI IN
AUDIO OUT
RS232C OUT
RS232C IN
USB
SD CARD
DP IN
IR /
AMBIENT
SENSOR IN
IR
OUT
(5V, 1.5A)
Port Description
RS232C IN
Connects to MDC using an RS232C adapter.
RS232C OUT
IR / AMBIENT SENSOR IN
Supplies power to the External sensor board or receives the light sensor signal.
RGB / DVI / HDMI / AV / COMPONENT /
AUDIO IN
Receives sound from a PC via an audio cable.
AUDIO OUT
Connects to the audio of a source device.
SD CARD
Connect to an SD memory card.
USB (5V, 1.5A)
Connect to a USB memory device.
―
The USB ports on the product accept a maximum constant current of 1.5 A.
If the maximum value is exceeded, USB ports may not work.
DVI IN / MAGICINFO IN
DVI IN: Connects to a source device using a DVI cable or HDMI-DVI cable.
MAGICINFO IN: To use MagicInfo, make sure to connect the DP-DVI cable.
DP IN
Connects to a PC using a DP cable.
HDMI IN
Connects to a source device using an HDMI cable.
RGB IN
Connects to a source device using a D-SUB cable.
DP OUT
Connects to another product using a DP cable.
AV IN / COMPONENT IN
Connects to a source device using the AV/Component adapter.
IR OUT
Receives the remote control signal via the External sensor board and outputs the
signal via LOOP OUT.
RJ45
Connects to MDC using a LAN cable.
To Next Page
Loading...
