troubleshooting _25
troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Does not have a
smoothly rotating
nozzle.
The nozzle hole is clogged with
food particles.
Clean the nozzle hole.
The nozzle is blocked by a dish or
pot and cannot rotate.
After placing the dishes into the racks,
rotate the nozzles by hand to check
whether any of the dishes will interfere with
them.
Water won’t
pump out of the
dishwasher.
Drain is clogged. Contact a qualified service technician to
remove any obstruction from the drain hose
and check the drain pump operation.
Has a bent upper
rack after loading
dishes.
The dishes are not loaded
properly.
Load your dishes as recommended.
(See page 16.)
05 troubleshooting
DMT800_DD68-00050A.indb 25 2010-08-09 4:07:47
To Next Page
Loading...
