RACK DRY (OPTIONAL PART)
Installing the drying rack
1. Open the Dryer door.
2. Position the drying rack in the tumbler, placing the front lip of the drying rack on the top of
the lint filter.
3. Place the rear legs in the two recessed areas of the dryer’s back wall, then push down the
middle of the drying rack to fix.
4. Place the items to be dried on the rack, leaving space between them so air can circulate.
5. Close the Dryer door.
6. Use the Time Dry cycle. Select the time according to the moisture and weight of the items.
Start the Dryer. It may be necessary to reset the timer if a longer drying time is needed.
SUGGESTED ITEMS SUGGESTED TEMP. SETTINGS
Washable sweaters
(block to shape and lay flat on rack)
Low or Extra Low
Stuffed toys
(cotton or polyester fiberfilled)
Low or Extra Low
Stuffed toys
(foam or rubber-filled)
Air Fluff
Foam rubber pillows Air Fluff
Sneakers Air Fluff or Heat (Extra Low)
Drying foam rubber, plastic, or rubber on a heat setting may cause damage to the item and
lead to a fire hazard.
Drying Rack is not supplied in this model. The Drying Rack is optional. You can purchase it
through a service center.
To Next Page
Loading...
