English22
Installation
Installation
STEP 5 Install the custom panel (For Fully Built-In models)
FBI (Fully Built-In, DW60A80**BB) models
Ø2
~8
1. Put the installation template on the
back of the custom panel and x it
temporarily using transparent tape. Note
that the rear of the custom panel will be
attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 3 kg and
7 kg.
• Thickness of the custom panel is
maximum 20 mm.
2. Mark 14 points guided on the
installation template.
A
B
A
B
3. Remove the installation template, and
then tighten the custom panel xers (A)
with 2 screws (B, Ø3.5 X 25) as shown in
the gure.
DW8500AM_DW60A8070BB_EE_DD81-03206E-04_EN.indd 22 2023-01-13 4:38:47
To Next Page
Loading...
