Samsung DW60H9970 Series - Page 19

Installing your dishwasher _19
03 INSTALLING
STEP7. COMPLETING THE INSTALLATION
1. Open the door and remove all foam, paper packaging, and unnecessary parts.
2. Turn on the circuit breaker you turned o before you began the installation.
3. Open the water supply valve to supply water to the dishwasher.
4. Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher is
operating.
Make sure to check for water leakage on both ends of the water supply line and drain hose
connector.
5. To install the kick plate, refer to the fi gure below.
1) Install the ‘Felt Lower’ onto the inside of the
‘Kick Plate’.
2) Models that are not equipped with the adjustable leg
3) Models that are equipped with the adjustable leg
Assemble the bracket in the right direction and order as shown in the fi gure.
CAUTION
7
7
5
5
48
small
Big
Big
Small
Install over 96.5mm
small
Big
Big
Small
Install over
96.5mm
BU-Install_DD68-00160B-07_EN.indd 19BU-Install_DD68-00160B-07_EN.indd 19 2017-02-08  1:28:482017-02-08  1:28:48