36_
Starting a Washing Programme
Program Description of cycle
Detergent (g)
(Pre wash / Main wash)
Running time
(min)
Energy
(KWh)
Water (L)
5/15
5/15
5/15
5/15
Quick Wash
Main Wash 40 °C
40 0.60 6.6
Hot Rinse 50 °C
Quick Wash + Hygiene
Main Wash 40 °C
49 0.95 6.6
Hot Rinse 70 °C
Quick Wash + Half load
Main Wash 40 °C
40 0.50 6.6
Hot Rinse 50 °C
Quick Wash + Rinse Add
Main Wash 40 °C
53 0.78 9.3
Hot Rinse 50 °C
9.310.021-hsaW erP
hsaW
erP
* SANS 50242:
The information for comparability test in accordance with SANS 50242,as follows:
• Capacity: 14 settings
• Position of upper basket: Lower position
• Rinse aid setting: 6
The wash time varies depending on the pressure and temperature of the supplied water.
Quick Wash, Express, Pre Wash: Continuous use of the Quick Wash, Express, Pre Wash cycles for an
extended time is not recommended. This may reduce the performance of the water softener.
Starting a washing programme
DW4000KM-00000A-00_EN (Basic)_160323.indd 26
Turning on the appliance
Starting a wash cycle...
1. Draw out the lower and upper basket, load the dishes and push them back.
It is recommended to load the lower basket fi rst, then the upper one (see the section entitled "Loading
the dishwasher racks").
2. Pour in the detergent (see the section entitled "Loading the Salt into the Softener").
3. Insert the plug into the socket. The power supply is 220-240 V AC 50 Hz, the specifi cation of the socket
is 10 A 250 VAC. 50 Hz.
4. Make sure that the water supply is turned on to full pressure. Close the door, press the "Power" button,
Press the "Program” button to select a desired "Wash cycle". (See the section entitled "Wash Cycle
Table"). With a little force to ensure the door is properly closed.
A click could be heard when the door is closed perfectly.
To Next Page
Loading...
