Samsung DW60M5050 Series - Page 7

Standard Disassembly Drawings _ 7
2-3. DOOR HINGE
- Door Hinge : DD82-01505A, DD82-01506A / SVC ASSY-DOOR LINK R, L
Part Figure Description
DOOR HINGE
B
A
[DISASSEMBLY]
* PREPARATION: Remove SIDE PANEL Left &
Right refer to the section of ‘CAP CASE BRAKE /
GASKET BRAKE’.
1. Remove 8 screws xing the ASSY CONTROL
PANEL with Torx® T15 screwdriver.
- Type A: DD81-01371A / 2 pcs
- Type B: DD81-02466A / 6 pcs
Warning
Be sure to remove the power plug before servicing.
Caution
The screws can fall into the SUMP after
disassembly. Keep the screws to other place to
reassemble the DOOR.
DW60M****F*
DW60M5050BB
2. Remove wire connector of Sub PBA.
NOTE :
In case of DW60M50**** models, remove the Door
switch assembly also.
C
3. Remove 6 screws to take off DOOR OUTER with
Torx® T15 screwdriver.
- Type C: DD81-01370A / 6 pcs
Warning
Be sure to remove the power plug before servicing.
Caution
Be careful to avoid injury when the DOOR is closed
after removing DOOR OUTER.
Caution
The screws can fall into the SUMP after
disassembly. Keep the screws to other place to
reassemble the DOOR.