Installing your dishwasher _35
07 INSTALLING YOUR DISHWASHER
3. If dishwasher is installed at the corner of the cabinet, there
should be some space when the door is opened.
cabinet
Dishwasher
Door of
Dishwasher
Minimum space
of 50 mm
Depending on where your electrical outlet is, you may need to cut a hole in the opposite cabinet side.
STEP 2. CHECKING WATER SUPPLY AND ELECTRICAL
REQUIREMENTS
• The water supply line pressure must be between 0.04-1.0 MPa.
• Supply cold water only. Make sure that the water temperature does not exceed 60 ˚C.
• Do not supply hot water. Otherwise, the product may malfunction.
• Use a rated power of 220-240 V~, 50 Hz.
• Install the product while the power cord is unplugged.
• Use a power outlet with a maximum allowable current of 16 A. (The maximum current for this dish
washer is 11 A.)
• When powering the dishwasher, ensure that your power supply has:
- An 220-240 V~, 50 Hz fuse or circuit breaker.
- An individual branch circuit serving your dishwasher.
• After the installation, check if the power cord is not bent or damaged.
• Ensure that the water supply valve is turned o before connecting the water supply line to the
dishwasher.
• Seal the water supply line connections using teflon tape or sealing compound to stop any water
leakage.
CAUTION
WARNING
DW60M5070IB_ET_DD81-02615K-00_EN.indd 35DW60M5070IB_ET_DD81-02615K-00_EN.indd 35 2019-09-17 2:50:442019-09-17 2:50:44
To Next Page
Loading...
