36_ Installing your dishwasher
STEP 3. PREPARING THE CUSTOM PANEL
This dishwasher model is equipped with an auto-balancing system in the door. It has a sliding hinge, which
is perfect for plinth-less kitchens or for installation above a small cupboard. Custom panel’s height (A) can
be between minimum 670 mm to maximum 800 mm depending on the installation environment. Custom
panel’s weight must not exceed 10 kg. Refer to the table for the height (C) in relation to the cabinet’s height
(B), and then determine the height of the custom panel.
A
596 mm
B
C
Min. 20
ABC
670-800 mm
820 mm 20-150 mm
850 mm 50-180 mm
880 mm 80-210 mm
1. Put the installation template on the back of the custom panel and fi x it temporarily using
transparent tape. Note that the rear of the custom panel will be attached to the dishwasher
door.
2. Mark 4 points guided on the installation template.
3. Remove the installation template and tighten the Custom panel fi xers as shown.
7
1
1
1
1
6
5
5
6
10
Installing your dishwasher
DW5500M_DD81-02437Q-00_EN.indd 36DW5500M_DD81-02437Q-00_EN.indd 36 2019-06-25 11:13:282019-06-25 11:13:28
To Next Page
Loading...
