Samsung DW60R2014 Series - Page 21

English 21English
Installation
1 in.
(24 mm)
⁄ in.
(15 mm)
⁄ in.
(18 mm)
1. Check the size of the sink’s drain hose
connector. If needed, cut the drain hose
so its end ts into the sink connector.
NOTE
If the drain hose does not t into the sink
connector, you can purchase an adaptor at
a plumbing/hardware store.
2. Insert the drain hose into the sink
connector, slide the hose clamp to the
end of the hose, and then tighten the
hose clamp.
Sink
Dishwasher
Drain
hose
Min. 20 in.
(508 mm)
3. When drilling a hole for the drain hose
on the cabinet wall, use caution not to
damage the drain hose on the sharp
edges of the hole.
- On wooden walls, use sand paper to
soften the edges.
- On metal walls, use insulation tape or
duct tape to cover the sharp edges
around the hole.
4. Secure the drain hose to the sink wall
using cable ties or other fastening
materials.
CAUTION
• Use caution not to damage the drain hose when installing the dishwasher.
• Install the drain system properly so that the drain hose does not disconnect from the
drain outlet in the draining process.
• Make sure that the drain hose, supply hose, or power cord is not kinked or folded.
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 21 12/28/2018 11:56:08 AM