Samsung DW60R2014 - Page 11

English 11English
Installation
STEP 2 Connect the hot water line
• The water line pressure must be between 20 psi and 120 psi (140–830 kPa).
• Make sure that the water temperature is delivered between 120 °F and 149 °F (49-
60 °C). Exceeding this limit may cause the dishwasher to malfunction.
• Make sure that the circuit breaker and water valve is turned off before connecting the
water supply line to the dishwasher.
• Make sure the water line is properly connected. Wrap Teon tape around every
connection and joint to prevent water leaks.
a
c
b
A
D
F
C
E
B
1. Use the provided nut connector
to connect the water hose to the
dishwasher.
Follow these steps:
a. Disconnect the 90° tting (A) from
the hose (B).
b. Remove the seal (C) and the nut (D)
from the 90° tting.
c. From the provided nut connector,
separate the seal (E) and the nut (F),
and then assemble them to the 90°
tting as shown in the gure. You
must insert the smaller side of the
seal.
Inlet valve 90° elbow
tting
Hot water
line
⁄"
(5 mm)
Water
valve
2. Insert the ⁄" 90-degree tting into the
inlet valve. Tighten the tting until it
points towards the water-hose channel
in the base of the dishwasher. Do not
overtighten.
3. Connect the hot water line to the tting.
4. If you want to secure the dishwasher to
the side wall for extra stability, bend the
brackets of the left and right housings
by referring to the gure.
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 11 12/28/2018 11:56:03 AM