English 13English
Installation
STEP 4 Install the custom panel (FBI models only (DW60R2014AP))
Ø2
~8
1. Put the installation template on the
back of the custom panel and x it
temporarily using transparent tape. Note
that the rear of the custom panel will be
attached to the dishwasher door.
CAUTION
• The top end of the custom panel must
be aligned with the top end of the
installation template.
• Use a custom panel between 7 lbs and
18 lbs.
2. Pre-drill the 14 points marked on the
installation template using a 2-pi drill bit
to a depth of
~
8 mm.
B
C
B
C
3. Remove the installation template and
tighten the custom panel xers (B) at
the top with 2 screws (C, Ø3.5 X 25) as
shown.
DW60R2014(A5)_IM_DD81-02707A-00_EN.indd 13 12/28/2018 11:56:04 AM
To Next Page
Loading...
