Samsung FE710DRS - Microwave Weight;EasyPh Sensor and Door Errors; Weight, EasyPh Sensor, and Door Open Issues

Code Cause Reason/Solution
E-3*
Weight Sensor Error
E-31
Sensor
Open
Sensor open error. Value of HEX is above “FF for 5 Seconds”.
Check if there is an unplugged sensor, loose wire connector,
or defective PCB.
E-32
Sensor
Short
Sensor short error. Check if the sensor shorted, or defective
PCB.
E-33
T1 Max
Time
Error
Sensor T1 Max Time Error. The initial value of HEX is under
“14” for 30 seconds while a weight sensor in operation. Check
sensor, or defective PCB.
E-34
Abnormal
Sensor
The initial value of K calculated by a weight sensor is above
and under ±28” as value of HEX.
E-35
Abnormal
Sensor
The value of A is “---” as a weight sensor calculates.
E-36
Door
Open
The door opens during sensor cooking. Check the door
latches & door switches. Cancel the present mode and restart.
E-4*
Easy/Ph Sensor Error
E-41
Sensor
Open
Sensor open error. Check if there is an unplugged sensor,
loose wire connector, or defective PCB.
E-42
Sensor
Short
Sensor short error. Check if the sensor shorted, or defective
PCB.
E-43
T1 Max
Time
Error
Sensor T1 Max Time Error. Check sensor, or defective PCB.
E-44
Dry Up /
No Load
Check if the food has already dry or the oven is empty. Insert
food and restart. Replace the sensor if necessary.
E-45
Cool
Error
Cooling Error, not temperature chance after 3 minutes.
Remove moisture from sensor and restart.
E-46
Open
Primary Open Error (3 Minutes). Check sensor, or defective
PCB.
E-47
Door
Open
The door opens during sensor cooking. Check the door
latches & door switches. Cancel the present mode and restart.
Microwave Ovens / OTRs Error Code List