206
Note:
The status LED begins to blink solid red to indicate
it has begun the start up process.
6. Connect your TV to the AllShare Cast Hub via an HDMI
cable (A-to-A cable) as shown above.
7. Change the source input on your TV to match the input
port used by the incoming HDMI cable.
Note:
The television screen should now display an on-screen
tutorial showing you how to configure your device’s
AllShare Cast Hub and device settings.
To activate AllShare Cast on your device:
1. From the main
Settings
page, tap
More settings
➔
AllShare Cast
.
2. If not already on, touch and slide the
AllShare Cast
slider to the right to turn it on. The slider color indicates
the activation status.
Pairing AllShare Cast Hub
To pair your device and Hub for the 1st time:
1. Locate the AllShare Hub (dongle) name displayed at the
bottom of the TV (showing the tutorial).
Ex: Name:
Dongle - XXXXXX
.
2. Access your device’s
AllShare Cast
screen and locate
the same hub/dongle name in the list.
•
Tap
Scan
if your AllShare Cast Hub (dongle) does not appear in
the list.
3. Verify your AllShare Cast Hub is on (blinking red LED)
and the on-screen tutorial is displaying on the
connected TV.
4. Verify the previous (
Wi-Fi Direct Active
) is
displayed.
LED Color/Patterns Description
Red - Solid
Indicates the AllShare Cast Hub is
booting or processing.
Red - Blinking
Indicates the AllShare Cast Hub is in
standby mode (ready for connection).
Blue - Solid
Indicates the AllShare Cast Hub is
ready to be connected with a new
device.
To Next Page
Loading...
