Media
86
Controlling the camera remotely
Set a device as a viewfinder to control the camera remotely.
Tap
→
→
Remote viewfinder
, and then connect the device and the camera using
Wi-Fi Direct or NFC. Tap
to take a photo remotely using the device as a viewfinder.
Configuring settings for Camera
Tap
→
to configure settings for Camera. Not all of the following options are available
in both still camera and video camera modes. The available options vary depending on the
mode used.
•
Photo size
/
Video size
: Select a resolution. Use higher resolution for higher quality. But it
takes up more memory.
•
Burst shot
: Take a series of photos of moving subjects.
•
Face detection
: Set the device to recognise people’s faces and help you take photos of
them.
•
Metering modes
: Select a metering method. This determines how light values are
calculated.
Centre-weighted
measures background light in the centre of the scene.
Spot
measures the light value at a specific location.
Matrix
averages the entire scene.
•
ISO
: Select an ISO value. This controls camera light sensitivity. It is measured in film-
camera equivalents. Low values are for stationary or brightly-lit objects. Higher values are
for fast-moving or poorly-lit objects.
•
Anti shake
/
Video stabilisation
: Activate or deactivate anti-shake. Anti-shake helps
focus when the camera is moving.
•
Auto night detection
: Set the device to automatically detect darker conditions and
adjust the brightness of the photo without the flash.
•
Save as
: Set the device to delete the original photo when taking photos with rich tone
mode.
To Next Page
Loading...
