Connections 82
– MAC address: View your device’s MAC address,
which is required when connecting to some secured
networks (not configurable).
– IP address: View your device’s IP address (not
configurable).
• WPS push button: Set up a connection to a WPS (Wi-
Fi Protected Setup) router or other equipment.
• WPS PIN entry: View the PIN used by your tablet to set
up a PIN-secured connection to a Wi-Fi router or other
equipment (not configurable).
•Help: Learn about setting up and using Wi-Fi networks,
and other settings.
Wi-Fi Direct
Wi-Fi Direct allows device-to-device connections so you
can transfer large amounts of data over a Wi-Fi connection.
These devices must be enabled for Wi-Fi Direct
communication. This connection is direct and not via a
hot spot or Wireless Access Point (WAP).
1. From a Home screen, touch ➔ Settings ➔
Connections tab ➔ Wi-Fi.
2. Touch the OFF/ON button to turn Wi-Fi ON .
3. Touch Wi-Fi Direct. Your device begins scanning for
other devices enabled with Wi-Fi Direct.
4. Enable Wi-Fi Direct on the target device.
5. In the list of available devices, touch the target device.
– or –
If you want to connect to more than one device, touch
Multi connect and touch each device to which you
want to connect that supports Multi-connect. Touch
Done.
6. On the target device, touch Accept (you have 30
seconds to touch Accept).
Once connected, the target device will show as
Connected in your list of Wi-Fi Direct devices and the
icon will display on the Status Bar.
To Next Page
Loading...
