Hotel TV Function
Description
Category Item Initial value
REACH
Solution
REACH 3.0 OFF
ON : The feature of REACH 3.0 in this TV becomes available.
OFF : The feature of REACH 3.0 in this TV becomes not available.
REACH Channel ...
Assign a DTV channel number to carry the update REACH data. This channel number must
be the same as the number set on the Reach server.
Group ID All
Select the Group ID of the REACH server.(Refer to the REACH server manual for more
details.)
Ticker OFF
ON : The Ticker content is displayed.
OFF : The Ticker content is not displayed.
REACH Update
Time
1hour
Lets you set when data such as updated SW, cloning files, and S-LYNC REACH contents is
downloaded from the REACH
server to the TV :
1hour : Every hour
2hour : Every 2 hours
12:00 am : Every 12:00 a.m.
12:00 pm : Every 12:00 p.m.
2:00 pm : Every 2:00 p.m.
REACH Update
Immediate
OFF
ON : Whenever the TV enters standby mode (the power cord is plugged in and the power is
off), the REACH data is updated on the TV.
OFF : The REACH data is only updated on the TV at the REACH server update time.
Room Number ... Set the Room Number.
REACH Server
Version
... The version of REACH Server is displayed.
Network
Network Setup Set an IP address to establish an Internet connection.
SmartHub Model
Setting
Set SmartHub Model.
SmartHub Setting Set up SmartHub.
Widget
Solution
Widget Mode ON Widget Mode ON/OFF.
Solution Type
Vendor
Server
Select type of solution (Vender Server/ SINC Server).
Server URL Setting Set server URL.
License Server IP
Setting
Set server IP.
IPTV Mode ON IPTV mode On/Off.
Virtual Standby OFF
Virtual Standby mode On/Off.
When Virtual Standby is On, TV power consumption will be 9.5W to 17.4W (Depending on
the size of the TV screen).
Instant On OFF Setup booting mode.
Room Num Setting Set Room Number.
System
Self Diagnosis
for TV
Enter Self Diagnosis Menu.
•Picture Test: Use to check for picture problems. If the problem appears in the test picture,
select Yes and follow the directions on the screen.
•Sound Test: Use the built-in melody sound to check for sound problems. If the problem
occurs during the test, select Yes and follow the directions on the screen.
Self Diagnosis for
HTV
HD Function Check Menu On Executing Item Below OSD is displayed ProIdiom DTV Channel
Key Loss : Ok/Failure (Hotel US) STB SI Vendor
Setting : SI Name Ok/Failure
Bathroom AMP : Ok/Failure (Hotel EU)
RTC : Ok/Failure (Hotel EU)
PC Audio Test : Ok/Failure
PC Self Test : Ok/Failure
SW Update SW USB Update function
Service Pattern OFF Same function with SVC Service Pattern.
Sound Bar Out OFF
ON: TV speaker sound will be mute. Sound will come out through HDMI.
You must connect the Sound Bar to hear the sound.
OFF: Sound will come out through TV speakers normally.
Contact Samsung
Display the web site of related Samsung service center, software version, and Mac address
information when the TV has a problem.
Standby LED OFF
When the TV is in standby mode, you can configure the settings of external LED.
•ON: The LED is on.
•OFF: The LED is off.
TV Reset Returns all settings on the TV to their factory defaults.
To Next Page
Loading...
