No
Hotel TV Function
Description
Category initial value
10
Bathroom
Speaker
Sub Amp Mode 2
Determines the Sub AMP operation mode.
− 0 : Turns the Sub AMP function off (PWM off).
− 1 : Determines the Sub volume according to the main volume control.
That is, the sub volume is determined according to the Power On Volume, the Min
Volume, and the Max.
− 2 : Determines the volume according to the bathroom control panel setting.
y HG890V model only can select 0 and 1.
Sub Amp Volume 6 Sub AMP Volume level at power on initial condition.
11
HP
Management
HP Mode OFF
For the specific situation, pls see the table below.
Default HP Volume …
Main Speaker ON
12
Eco
Solution
Energy Saving OFF
This feature adjusts the brightness of the TV in order to reduce power
consumption.
− Off : Turns off the energy saving function.
− Low : Sets the TV to low energy saving mode.
− Medium : Sets the TV to medium energy saving mode.
− High : Sets the TV to high energy saving mode.
13
Logo
/Message
Welcome Message OFF Display Welcome Message.
Edit Welcome Message Edit Welcome Message.
Hospitality Logo OFF
User can set the logo display Off or the type of logo file(BMP/AVI). (Can't use at
the same time with "Welcome Message")
Hospitality Logo DL ... Download the logo file from USB toTV.
Logo Display Time ... Set the logo display time (3/5/7 Seconds).
14 Cloning
Clone TV to USB
USB Clone: TV → USB
Clone USB to TV
USB Clone: USB → TV
Setting Auto Intialize OFF
When Setting Auto Initialize is set to On, and the power is turned off and on or
the Master Power is turned off and on, the data is restored to the cloned values.
If there is no cloned value, even when the Setting Auto Initialize is set to On, it will
be ignored and the operation will be the same as that whenSetting Auto Initialize
is set to Off.
15
REACH
Solution
REACH 3.0 OFF
− OFF : Close REACH 3.0.
− ON : Open REACH 3.0.
REACH 2.0 OFF
− OFF : Close REACH 2.0.
− ON : Open REACH 2.0.
REACH Channel ...
87:Assign a DTV channel number to carry the update REACH data. This channel
number must be the same as the number set on the Reach server.
Group ID ...
All:Select the group ID of the REACH server. (Refer to the REACH server manual
for more details)
Ticker OFF
− ON : The TICKER content is displayed.
− OFF : The TICKER content is not displayed.
REACH Update Time ...
Lets you set when data such as updated SW, cloning files, and S-LYNC REACH
contents is downloaded from the REACH server to the TV :
− hour : Every hour.
− 2hour : Every 2 hours.
− 12:00 am : every 12:00 a.m.
− 2:00 am: every 2:00 a.m.
− 12:00 pm : every 12:00 p.m.
− 2:00 pm : every 2:00 p.m.
REACH Update
Immediate
...
− ON : Whenever the TV enters standby mode (the power cord is plugged in
and the power is off), the REACH data is updated on the TV.
− OFF : The REACH data is only updated on the TV at the REACH server
update time.
Room Number … Setting Room Number.
REACH 2.0 TV Sound ...
− OFF: Close REACH 2.0 TV Sound.
− ON: Open REACH 2.0 TV Sound.
REACH 2.0 Server
Version
... 0000: Displays the current REACH data version.
16 Network
Network Setup Set IP address to establish Internet connection.
SmartHub Model
Setting
Set Hotel ID.
SmartHub Setting Enter to Smart Hub setting interface.
To Next Page
Loading...
