English - 129
• For replacement, you will need a 5.91-Inch screwdriver and a pair of gloves.
1
Unplug TV, then use a
screwdriver to remove the
screws.
2
Remove the Lamp cover.
3
Remove the Lamp cover duct
holding the locker and pulling
it out.
4
Remove the screw securing
the Lamp by using a
screwdriver.
5
Separate the Lamp from the
engine by holding the handle
and pulling it out.
NOTES
• Be sure the replacement Lamp is the same type.
• After replacing the lamp, align the lamp cover with the groove and secure the screws.
• The TV will not turn on if the lamp cover is not correctly closed (as this will activate the protective
circuit).
BP68-00586A-00Eng(128~131) 2/16/06 8:18 PM Page 129
To Next Page
Loading...
