System Upgrade by CD Method for HT-BD2
Introduction
This manual describes System Upgrade procedure for HT-BD2. If you have any problems during
System Upgrade, please contact Samsung Customer Service Center.
How to make a firmware update CD
Please follow the below procedures.
1 Download the new ‘firmware’ file from www.samsung.com
2 If the firmware file is compressed (*.zip/rar), the file should be uncompressed to CD image
file (*.iso).
3 Please burn the CD image file on a blank CD-R/RW disc
1) Recommended CD Burning Program is Nero Burning ROM.
2) Burning Options (in case of using Nero Burning ROM)
A. ‘Recorder’ menu ‘Burn Image…’ Select an uncompressed image file(*.iso)
B. Please check ‘Finalize CD (No further writhing possible!)’
C. Please refer to your own CD burning Program Manual if you want to use any other
CD burning program for burning ISO image file.
D. Make sure if the downloaded software is eligible for your HT-BD2.
E. The system upgrade may not be executed if the update CD was made without
following the upper procedure
Warning
The following events may interrupt the upgrade process and MAY RESULT IN PERMANENT
DAMAGE TO THE UNIT WHILE UPGRADING.
1. Unplugging the power plug
2. Power Outage
3. Dirt or Scratches on the burned CD-R/RW disc
4. Closing or opening the disc tray during the update process
How to upgrade the HT-BD2
1. Press OPEN/CLOSE button to open the disc tray.
2. Insert the upgrade CD.
3. Press OPEN/CLOSE button to close the disc tray.
4. Please wait about 6 minutes while verifying.
Verifying Firmware Version.
5. When below message box comes up, please check the date of the Firmware version.
To Next Page
Need help?
General
