Samsung HT-C460 - 4-4 Buyer-Region Code Setting Method; 4-4-1 The inserting method of Region Code after replacing the Main PBA

Samsung Electronics 4-21
Troubleshooting
TEST
4-4 Buyer-Region Code Setting Method
4-4-1 The inserting method of Region Code after replacing the Main PBA
[Reference]
- When replacing the Main PBA and System Micom should be inserted the region code.
- The set is not working properly if you don't insert the region code.
- The region code is inserted by the remote control.
1. Press the “AUX” button on the remote control.
2. Press the "TUNER MEMORY" button on the remote control during
4~5 seconds.
3. After step (2), you can see “TEST” on the VFD.
4. When you see “TEST” on VFD, Insert number “4”, “6” to start
Region Code setting mode.