GB
1413
CONNECTIONS
Speaker Installation
How to install the speaker and the stand (Tallboy type)
How to install the speaker and the stand (Half tallboy type)
2 3
4 5 6
1
Turn the STAND (B) upside-down
and connect it to the STAND
BASE (C).
Turning the screw (D) clockwise,
connect it to two holes marked
with the arrow using a screwdriver
as shown in the ullustration.
Turning the supplied screw (E)
clockwise, connect it to a hole on
the rear of the Speaker.
Connect the assembled stand to
the SPEAKER (A).
Turning the screw (E) clockwise,
connect to a hole on the rear of
the speaker using a screwdriver as
shown in the illustration.
This is the successfully assembled
speaker.
* Make sure that the TALLBOY type
speaker should be installed on the flat
and stable area. Otherwise it may fall
down due to external shock.
Component
A: SPEAKER
B: STAND
C: STAND BASE
D: Screw
E: Screw
Component
A: SPEAKER
B: STAND
C: STAND BASE
D: Screw
E: Screw
2 3
4
1
Connect the SPEAKER (A) with
the STAND BASE (C).
Turning the screw (D) clockwise,
connect it to two holes marked
with the arrow using a screwdriver
as shown in the illustration.
Turning the screw (E) clockwise,
connect to a hole on the rear of
the speaker using a screwdriver as
shown in the illustration.
This is the successfully assembled
SPEAKER (A).
To Next Page
Loading...
