41
6. FAN Error Check
6. FAN Error Check
HT-X715 has one small Fan and Fan Circuit to control the temperature of the SET
inside
FAN is Automatically worked (Approximately 45 Sec after power On)
If there are problems, “FAN CHK” will be displayed and power off.
1.Symptom
2.Methood
2.FAN Circuit
AMP PCB
1.FAN Connection
Check
Display “FAN CHECK” Power Off (about 1 minute)
1.Check the Fan Connector AMP PCB [AJ4]
2.Check around the Fan (something is blocking the FAN or not)
3.Check the FAN Circuit (Check FAN circuit is shorted or opened )
To Next Page
Loading...
