Samsung HW-Q800B - Page 46

Using the Q-Symphony Function
For Q-Symphony, the Sound bar syncs with a Samsung TV to
output sound through two devices for optimum surround
effect. When the Sound bar is connected, the menu,
"TV+Soundbar" appears under the Sound Output menu of
the TV. (The message above differs with the TV model.)
• TV menu example: TV+ [AV] Sound bar series name
(HDMI/Wi-Fi)
NOTE
• It can operate according to the Codec supported by TV.
• This function is supported only when the HDMI Cable or
Optical Cable (not supplied) orWi-Fi is connected.
• The message displayed may differ with the TV model.
• Ensure that your TV and Sound bar are connected to the
same wireless router/frequency.
• This function is available in some Samsung TVs and
some Sound bar models.
Using the Spacefit sound
Provides optimized sound quality by analyzing the listening
spaces.
05 USING A WIRELESS
CONNECTION
Connecting via Bluetooth
Top of the Soundbar
OR
D
··t··
OR
What is the difference between BT READY and BT
PAIRING?
• BT READY: In this mode, you can reconnect any
Samsung TV or mobile device that was connected
before.
• BT PAIRING: In this mode, you can connect a new device
to the Sound bar.
(Press the t PAIR button on the Sound bar remote
control or press and hold the 0 (Mic On/Off) button on
the top of the Soundbarfor more than 5 seconds while
the Sound bar is in "BT" mode.)
NOTE
• If asked for a PIN code when connecting a Bluetooth
device, enter <0000>.
Connecting via Wi-Fi (Wireless
Network)
• To connect a Sound bar to a mobile device via a wireless
network (Wi-Fi), the SmartThings app is required.
1. Connect your mobile device (smartphone, tablet, etc.) to
the Wi-Fi network the TV is connected to.
2. Install and launch the SmartThings app on your mobile
device (smartphone, tablet, etc.).
3. Follow the instructions in the app screen on the mobile
device to connect the Sound bar to yourWi-Fi network.
06 TROUBLESHOOTING
Refer to the instructions below if this product does not
function properly. If the problem you are experiencing is
not listed below or if the instructions below do not help,
turn off the product, disconnect the power cord, and
contact Samsung Electronics at 1-800-SAMSUNG (1-800-
726-7864).
Sound bar does not turn on.
• Check whether the power cord of the Sound bar is
correctly inserted into the outlet.
Soundbarworks erratically.
• After removing the power cord, insert it again.
• Try again after initializing the product.
• If there is no signal, the Sound bar automatically turns
off after a certain period of time. Turn on the power.
Remote control does not work
• Point the remote directly at the sound bar.
• Replace the batteries with new ones.
Sound is not output from the sound bar.
• The volume of the Sound bar is too low or muted.
Adjust the volume.
• When any external device (STB, Bluetooth device,
mobile device, etc.) is connected, adjust the volume of
the external device.
• For sound output of the TV, select Sound bar. (Samsung
TV: Home ( (n]) ➔ Settings (@) ➔ Sound ➔ Sound
Output ➔ Select Soundbar)
• Remove the cable from the Sound bar and then
reconnect it.
Sound is not output from the subwoofer or the rear
speakers.
• Check whether the LED on the rear of the Su bwoofer
and Surround Speakers lights in blue. Reconnect it
when the blue LED blinks or the red LED lights.