Samsung LA32D450G1M User Manual (English)

Questions and Answers:

N
Natalie LozanoAug 1, 2025
Why is Anynet+ not working on my Samsung LA32D450G1M?
- S
  Steven JacobsAug 2, 2025
  Anynet+ may not work for several reasons. Ensure the device is Anynet+ compatible, and only one receiver is connected. Check the power cord, Video/Audio/HDMI cable connections, and that Anynet+ (HDMI-CEC) is set to On in the System menu. Also, verify the TV remote is in TV mode and is Anynet+ compatible. Note that Anynet+ may not function during certain operations like channel searching or initial setup. After connecting or disconnecting the HDMI cable, rescan devices or power cycle the TV. Finally, confirm the Anynet+ function on the external device is enabled.
A
Angela PachecoAug 7, 2025
What to do if connected device is not displayed on Samsung LA32D450G1M?
- W
  wallerlisaAug 8, 2025
  If the connected device is not displayed, verify that the device supports Anynet+ functions and that the HDMI cable is properly connected. Check if Anynet+ (HDMI-CEC) is enabled in the System menu. Try rescanning for Anynet+ devices. Ensure you are using an HDMI cable that supports Anynet+ and if there was a power interruption or cable disconnection, repeat the device scan.
T
Tracey OwensAug 13, 2025
How to start Anynet+ on Samsung LA32D450G1M?
- S
  Steven LittleAug 13, 2025
  To start Anynet+, ensure the device is properly connected to the TV and that Anynet+ (HDMI-CEC) is set to On in the System menu. Then, press the TOOLS button to display the Anynet+ menu and select the desired option.
L
Laura BarrettAug 20, 2025
How to exit Anynet+ on Samsung LA32D450G1M?
- L
  lesteramberAug 20, 2025
  To exit Anynet+, select View TV in the Anynet+ menu. Alternatively, press the SOURCE button on the TV remote and select a device other than an Anynet+ device. You can also press the > CH < button to change the TV mode, but note that the channel button only works when a tuner-embedded Anynet+ device is not connected.
L
Luis BennettAug 26, 2025
What to do if Samsung LA32D450G1M displays 'Connecting to Anynet+ device...' message?
- S
  schwartzbenjaminAug 26, 2025
  When the message “Connecting to Anynet+ device...” appears, you cannot use the remote control during the configuration or switching to a view mode. Please wait until the Anynet+ setting or switching to view mode is complete before using the remote control.

Samsung LA32D450G1M Specifications

General

Screen Size	32 inches
Resolution	1366 x 768
Display Type	LCD
HDMI Ports	2
USB Ports	1
Aspect Ratio	16:9
Refresh Rate	50 Hz
Dynamic Contrast Ratio	Mega Contrast
Viewing Angle (H)	178 degrees
Viewing Angle (V)	178 degrees
Sound Output	10W x 2
Speaker Type	Down Firing
Component Ports (Y/Pb/Pr)	1
Composite Ports (AV)	1
PC Input (D-Sub)	1
RF In (Terrestrial/Cable Input)	1
Digital Audio Out (Optical)	1
Headphone	1
Ethernet	No
Wireless LAN	No
Power Consumption (Standby)	0.3 W
Operating Temperature	10°C to 40°C
Operating Humidity	10% to 80%