15
Removing the Stand
―
Before removing the stand from the product, place the product on a flat and stable surface with the screen facing down.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
1
2
3
4
Place the protective Styrofoam (cushion) included
in the package on the floor and place the product
facing down on the Styrofoam, as shown in the
image. If Styrofoam is unavailable, use a thick
sitting mat.
While holding the product with one hand, pull the
stand neck with your other hand to in detach the
stand as shown in the figure.
Turn the connecting screw at the bottom of the
stand base to separate it.
Remove the stand neck from the stand base by
pulling it in the direction of the arrow as shown in
the figure.
To Next Page
Loading...
