26
Tidying Up the Connected Cables
1
Tilt the display, as shown in the figure. Rotate the machine to the highest vertical
position.
Connect the corresponding cables. Arrange the cables through the groove on the
COVER-REAR, and then attach the COVER-REAR
SUB. When you attach the COVER-REAR SUB,
please aim six ribs of the COVER-REAR SUB to
the bottom holes of the COVER-REAR at first.
Open the COVER-STAND NECK LEFT, and rotate the
open part at the bottom.
Place the corresponding cables into the stand-
neck holder. Do not stretch the line. Three cables
in one holder is recommended.
Cover the COVER-STAND NECK LEFT.
Rotate the machine to the horizontal position.
To Next Page
Loading...
