To Next Page
M
Melanie DeckerJul 25, 2025
What to do if the connected device is not displayed on my Samsung ?
- DDouglas SandersJul 26, 2025
If the connected device is not displayed, verify that the device supports Anynet[+] functions and that the HDMI 1.3 cable is properly connected. Check if Anynet[+] (HDMI-CEC) is set to On in the Anynet[+] setup menu. Try searching for Anynet[+] devices again. Ensure you are using an HDMI 1.3 cable, as some HDMI cables may not support Anynet[+] functions. If the connection was interrupted (e.g., HDMI cable disconnection, power failure), repeat the device scan.
General
