◀ ▶
Problem Possible❑Solution
I want to start Anynet+.
●
Check if the Anynet+ device is properly connected to
the TV and check if the❑Anynet+❑(HDMI-CEC) is set to
On in the System menu.
●
Press the TOOLS button to display the Anynet+ menu
and select a menu you want.
I want to exit Anynet+.
●
Select View❑TV in the Anynet+ menu.
●
Press the SOURCE button on the TV remote control
and select a device other than Anynet+ devices.
●
Press
❑CH❑
, CH❑LIST and PRE-CH to change
the TV mode. (Note that the channel button operates
only when a tuner-embedded Anynet+ device is not
connected.)
English
To Next Page
Loading...
