◀ ▶
Issues Solutions❑and❑Explanations
You turned the TV off
45 minutes ago, and it
turned on again.
●
It is normal. The TV operates the OTA (Over The Aerial)
function itself to upgrade firmware downloaded whilst
your watching TV.
The message
“Scramble❑signal”
or “Weak❑Signal/No❑
Signal” appears.
●
If you are using a CAM CARD (CI/CI+), check that it is
installed into the common interface slot.
●
If there is still a problem, pull the CAM CARD out of the
TV and insert it into the slot again.
There are recurrent
picture/sound issues.
●
Check and change the signal/source.
A reaction may occur
between the rubber
cushion pads on the
base stand and the
top finish of some
furniture.
●
To prevent this, use felt pads on any surface of the TV
that comes in direct contact with furniture.
English
To Next Page
Loading...
