Picture
Option Description
Picture Options
100Hz Motion Plus → Off / Clear / Standard / Smooth
/ Demo
The TV can be set to automatically sense and process film
signals from all sources and adjust the picture for optimum
quality.
If you enable 100Hz Motion Plus, noise may appear on
the screen. If this occurs, set 100Hz Motion Plus to off or
select one
of the other options.
Off: Switches 100Hz Motion Plus off.
Clear: Sets 100Hz Motion Plus to minimum.
Standard: Sets 100Hz Motion Plus to medium.
Smooth: Sets 100Hz Motion Plus to maximum.
Custom: Adjusts the blur and judder reduction
level to suit your preference.
Blur Reduction: Adjusts the blur reduction level in
video sources.
Judder Reduction: Adjusts the judder reduction
level in video sources with film signals.
Reset: Reset the custom settings.
Demo: Displays the difference between 100Hz
Motion Plus on and off modes.
Blue Only Mode
Helps to adjust the colour and tint controls when used with
colour bar test patterns. Recommended for qualified picture
alignment specialists only. Available only when the Picture
Mode is set to Movie or Standard.
■
●
●
●
■
Picture Reset
Resets all picture settings to the default values.
Reset Picture Mode: Current picture values return to
default settings.
■
Picture (In the PC mode)
Option Description
Auto Adjustment
Use the Auto Adjust function to have the TV set
automatically adjust the video signals it receives.
The function also automatically fine-tunes the settings and
adjusts the frequency values and positions.
Screen
Coarse / Fine
The purpose of picture quality adjustment is to remove or
reduce picture noise. If the noise is not removed by Fine-
tuning alone, then adjust the frequency as best as possible
(Coarse) and Fine-tune again. After the noise has been
reduced, readjust the picture so that it is aligned on the
centre of screen.
PC Position
Adjust the PC’s screen positioning if it does not fit the TV
screen.
Press the ▲ or ▼ button to adjusting the Vertical-Position.
Press the ◄ or ► button to adjust the Horizontal-Position.
Image Reset
You can replace all image settings with the factory default
values.
■
■
■
Blue Only Mode is available
when the picture mode is set to
Movie or Standard.
■
Preset: Press the SOURCE button
to select PC mode.
This function does not work in
DVI-HDMI mode.
■
■
Press the TOOLS button to
display the Tools menu. You can
also set the Auto Adjustment
by selecting Tools → Auto
Adjustment.
■
To Next Page
Loading...
