English-7
Connecting VHF and UHF Antennas
If your antenna has a set of leads that
look like this, see “Antennas with
300-ohm Flat Twin Leads” below.
If your antenna has one lead that looks
like this, see “Antennas with 75-ohm
Round Leads” on page 8.
If you have two antennas, see “Separate
VHF and UHF Antennas” on page 8.
Antennas with 300-ohm Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has
300-ohm twin flat leads, follow the directions below.
1
Place the wires from
the twin leads under
the screws on a 300-75
ohm adapter
(not supplied).
Use a screwdriver to
tighten the screws.
2
Plug the adapter into
the ANT IN terminal
on the back of the TV.
Chapter 2
C ONNECTIONS
BN68-00883A-00Eng.qxd 3/9/05 11:04 AM Page 7
To Next Page
Loading...
