"-
Air
?f
~
,;
·4
Air
"
"
~
4-2
'TVIIS
'"
"-
Air
,;;.
13
Air
13-1
'TV#3
A1ice'sAdventures
in
Wonderland
-loom
-select
TOOlS
CHANNEL
CONTROL
• Configuring the Channel Menu
o Antenna
->
Air I Cable
Before your television can begin memorizing the available channels, you must specify the type
of signal source that
is
connected to the TV (i.e.
an
Air or a Cable system).
~
Press the TOOLS button to display the
Tools
menu.
You
can also set the Antenna by
selecting Tools
--+
Switch
to
Cable (or
Switch
to
Air).
o Auto Program
::>
Air:
Air
antenna
signal.
! Cable: Cable
antenna
signal.!
Auto:
Air
and
Cable
antenna
signals
lEI
When selecting the Cable TV system: Selects the cable system. STD, HRC and IRC
identify various types
of
cable TV systems. Contact your local cable company
to
identify the type of cable system that exists
in
your particular area. At this point the signal source has been selected.
@?)
After all the available channels are stored, it starts to remove scrambled channels (Clear Scrambled Channels). The Auto
program menu then reappears.
lEI
If you want to stop Auto Programming, press the ENTER G button. The
Stop
Auto
Program?
message will be displayed.
Select Yes by pressing
the'"
or
..
button, then press the ENTER G button.
o Clear Scrambled Channels (digital channels only)
This function
is
used to filter out scrambled channels after
Auto
Program
is
completed. This process may take up to 20-30
minutes.
lEI
To
stop searching scrambled channels: Press the ENTER G button to select Stop. Press
the'"
button
to
select Yes, then
press the ENTER G button.
lEI
This function
is
only available
in
Cable mode.
o Channel List
For detailed procedures
on
using the
Channel
List, refer to the 'Managing Channels' instructions.
rEl
You
can select these options
by
simply pressing the CH LIST button on the remote control
o Fine Tune (analog channels only)
Use fine tuning to manually adjust a particular channel for optimal reception.
o If you do not store the fine-tuned channel
in
memory, adjustments are not saved.
o * will appear next to the name of fine-tuned channels.
@j
To
reset the fine tuning setting, press the T button to select Reset, then press the ENTER G button.
• Managing Channels
Using this menu, you can add I delete or set favorite channels and use the program guide for
digital broadcasts.
l:ll
All
Channels
Shows all currently available channels.
~I
Added
Channels
Shows all added channels.
Favorite
Shows all favorite channels.
rEl
To
select the favorite channels you have set up, press the FAV.CH button on the remote control.
To Next Page
Loading...
