Samsung MAX-485 - Page 4

1-10.Components, parts, and/or wiring that appear
to have overheated or that are otherwise
damaged should be replaced with components,
parts and/or wiring that meet original
Antenna
Terminal
specifications.
Additionally,
determine
the
cause of overheating and/or damage and, if
necessary, take corrective action to remove any
Exposed
potential
safety
hazard.
Melal Part
1-11.Product Safety Notice-Some electrical and
Ohmmeter
mechanical
parts
have
special
safety-related
characteristics which are often not evident from
visual inspection, nor can the protection they
give necessarily be obtained by replacing them
FIG.
2
Insulation
Resistance
Test
with
components
rated
for
higher
voltage,
wattage, etc. Parts that have special safety
1-7.
Read
and
comply
with
all
caution
and
safety-
characteristics
are
identified
by
shading,
an
(x)
related
notes
non
or
inside
the
cabinet,
or
on
the
or
a
(/1\)
on
schematisc
and
parts
lists.
Use
of
a
chassis.
substitute
replacement
that
does
not
have
the
same safety characteristics as the recommend-
1-8.
Design
Afteration
Warning-Do
not
alter
or
add
to
ed
replacement
part
might
created
shock,
fire
the
mechanical
or
electrical
design
of
this
and/or
other
hazards.
Product
safety
is
under
instrument.
Design
alterations
and
additions,
review
continuously
and
new
instructions
are
including
but
not
limited
to,
circuit
modifications
issued
whenever
appropriate.
and the addition of items such as auxiliary audio
output connections, might alter the safety
characteristics of this instrument and create a
hazard to the user. Any design alterations or
additions will make you, the servicer, responsible
for personal injury or property damage resulting
therefrom.
1-9. Observe original lead dress. Take extra care to
assure correct lead dress in the following areas:
(1) near sharp edges, (2) near thermally hot parts
(be sure that leads and components do not touch
thermally hot parts), (3) the AC supply, (4) high
voltage, and (5) antenna wiring. Always inspect
in all areas for pinched, out-of-place, or frayed
wiring. Do not change spacing between a
component and the printed-circuit board. Check
the AC power cord for damage.