CHECKING THAT YOUR OVEN IS OPERATING
CORRECTLY
The following simple procedure enables you to check that your oven is working correctly
at all times. If you are in doubt, refer to the section entitled “Troubleshooting” on the
40-41 page.
The oven must be plugged into an appropriate wall socket. The turntable must be
inpositionintheoven.Ifapowerlevelotherthanthemaximum(100%-900W)is
used, the water takes longer to boil.
Open the oven door by pulling the handle on the right side of the door.
Placeaglassofwaterontheturntable.Closethedoor.
Press the Start/+30s button and set the time to 4 or 5 minutes,
by pressing the Start/+30s button the appropriate number of
times.
Result: The oven heats the water for 4 or 5 minutes.
The water should then be boiling.
SETTING THE TIME
Yourmicrowaveovenhasaninbuiltclock.Whenpowerissupplied,“88:88”andthen
“12:00”isautomaticallydisplayedonthedisplay.
Please set the current time. The time can be displayed in either the 24-hour or 12-hour
notation. You must set the clock:
•
When you first install your microwave oven
•
After a power failure
Do not forget to reset the clock when you switch to and from summer and winter time.
1. Press the Clock button.
2. Press the Up or Down button to set time display type (12H
or24H).Atthattime,presstheSelect button to set the
display type.
3. Press the Up or Down button to set the hour.
4. Press the Select button.
5. Press the Up or Down button to set the minute.
6. When the right time is displayed, press the Select button to
start the clock.
Result: The time is displayed whenever you are not
using the microwave oven.
MC28H5015AK_EF_DE68-04234C-00_EN.indd 15 2013-12-17 �� 1:04:07
To Next Page
Loading...
Need help?
General
