Samsung Electronics 3-5
No Parts Procedure Remark
3
4
5
6
Fan
&
Motor
Heat Exchanger
Ass'y Valve
4 way
&
Ass'y Valve EEV
Compressor
1) Release the refrigerant at first.
2) Loosen fixing screw(CW).
(Use Monkey Spanner.)
3) Disassemble the fan and motor
1) Loosen 2 fixing screws(CCW)on both
sides. (Use +Screw Driver.)
2) Disassemble the pipes in both inlet and
outlet with welding torch.
3) Detach the Heat Exchanger.
Before you disassemble the pipes
and Condenser,be sure that there
should be no refrigerant remained
in the unit.
1) Loosen 8 bolts(CCW)fixed to assemble
Valve Service with Bracket Valve like the
picture on the right side.
(Use Monkey Spanner.)
2) Disassemble the pipes assembled the
suction and discharge sides of the
Compressor with welding torch.
1) Loosen the Nut(CCW)of Terminal Cover.
(Use Monkey Spanner.)
2) Detach the Terminal Cover and detach
the Connect Comp Wire from
Compressor.
3) Disassemble the Felt Comp Sound.
4) Loosen the 3 bolts(CCW)at the bottom
of Compressor like the picture on the
right side. (Use Monkey Spanner.)
To Next Page
Loading...
