Samsung MH026FAEA - Page 80

4-24 Samsung Electronics
1. Check whether power is supplied or not.
- When the indoor unit is not plugged in, there should be additional power
supply in the indoor unit.
2. The panel(display ) should be connected to an indoor unit to receive option.
3. Before installing the indoor unit, assign an address to the indoor unit according
to the air conditioning system plan.
4. Assign an indoor unit address by wireless remote controller.
- The initial setting status of indoor unit ADDRESS(MAIN/RMC) is "0A0000-100000-200000-300000"
- There is no need to assign extra ADDRESS for 1:1 installation between indoor unit and outdoor unit.
Option No. : 0AXXXX-1XXXXX-2XXXXX-3XXXXX
Option 4&( 4&( 4&( 4&( 4&( 4&(
Explanation 1"(& MODE
Setting Main
address
100-digit of indoor
unit address
10-digit of indoor
unit
A single digit of
indoor unit
Remote
Controller
Display
Indication
and Details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
0A
0
No Main
address
0~9
100-digit 0~9 10-digit 0~9
A single
digit
1
Main
address
setting
mode
Option 4&( 4&( 4&( 4&( 4&( 4&(
Explanation 1"(&
Setting RMC
address
(SPVQ
channel(*16)
(SPVQBEESFTT
Remote
Controller
Display
Indication
and Details
Indication Details Indication Details Indication Details Indication Details Indication Details Indication Details
1
0
No RMC
address
RMC1 1~F RMC2 1~F
1
RMC
address
setting
mode
Setting an indoor unit address (MAIN/RMC)
Indoor Unit
1(L)
2(N)
F2
F1
※
You must set RMC address setting mode when using the centralized Control .
(AQV07/09/12/18/24****)