Disassembly and Reassembly
4-17Samsung Electronics
No Parts Procedure Remark
1
2
Filter-Pre
Blower
&
Duct
1) Disassemble screws of indication part and
then assemble the direction of
2 Plate-Handle places by use of screw
as shown in 2).
2) Turn the Plate Handle by hand when
removing the Filter-Pre.
3) When pulling the Filter-Pre handle,
the Filter-Pre can be assembled.
✳ Be sure to remove the cushion on the
marked part after initial installation.
(It cause the damage of noise).
1) After disassembling places indicating screws,
detach Ass'y Cover Bottom.
4-1-4 MH✳✳✳FDEA (Silhouette Duct)
24296A(1)_1 11/11/05 5:03 PM Page 4-17
To Next Page
Loading...
