E-14
Connecting the Cables to the Outdoor Unit
Two electric cables must be connected to the outdoor unit:
◆
The assembly cable connecting the indoor unit to the outdoor unit.
◆
The power cable connecting the auxiliary circuit breaker to the
outdoor unit.
1 Remove the terminal board cover on the side of the outdoor unit.
2 Connect the assembly cable with the power cable such as figure.
➢ Each wire is labelled with the corresponding terminal number.
➢ Ensure the wire number of the indoor unit and the terminal
number of the outdoor unit.
3 Connect the earth wires to the earth terminals.
➢ Refer to the page opposite for further details on how to check
that earthing is correct.
4 Replace the terminal board cover, carefully tightening the screw.
5 Connect the power cable to the auxiliary circuit breaker.
➢ Specially for Russian and European market, before installation,
the supply authority should be consulted to determine the
supply system impedance to ensure compliance.
I
NSTALLING THE
O
UTDOOR
U
NIT
Type A
Type B
Type C
To Next Page
Loading...
