Samsung ML 1630 - Preparation for Cartridge Remanufacturing; Required Tools; Required Supplies

UNINET IMAGING INC. • SAMSUNG ML 1630 CARTRIDGE REMANUFACTURING INSTRUCTIONS
REQUIRED TOOLS
1. Toner Approved Vacuum
2. A Small Common Screw Driver
3. A Phillips Head Screwdriver
4. Needle Nose Pliers
REQUIRED SUPPLIES
1. 40g Toner
2. New Replacement Chip
3. Conductive Grease
4. 99% Isopropyl Alcohol
NOTES
1. Place the cartridge with the handle up, facing towards you.
Remove the three screws from the right side end cap.
2. On the left side end cap, remove the three screws.