Receiver & Display Unit Installation - Concealed Type
E-4
Accessories
MRK-A00, A00U
Receiver &
display unit (1)
STS 2S-2x10
tapped screw (4)
2S-4x12 tapped
screw (2)
Owner’s
instructions(1)
Installation
manual (1)
Wire kit
(Length:10m)
Remove the receiver & display unit cover by using the
tab on its bottom.
1
Open the receiver & display unit.
2
Connect the end of the connector wire to the receiver
& display unit and connect the other end of the wire to
the MAIN PCB (CN91) as shown in figure.
3
CC
CC
AA
AA
UU
UU
TT
TT
II
II
OO
OO
NN
NN
Do NOT keep the receiver & display unit cable
with a 220V cable because the remote controller
cables have low voltage.
◆
Receiver &
display unit
To Next Page
Loading...
